I am trying to use TAG CP750 and ALGE GAZ4, but I am not getting any data from computer to display board. With TDC 4000 it works no problem. Do I have to chance CP750 setting - transfer speed, or is it somethig different?
Deuce
Original Post
Replies sorted oldest to newest
Make sure you have a GAZ4 that has the modification to work with 9600 baud. The standard main circuit board works at 2400 baud only. We can make the modification at our shop. Only the main circuit board needs to be sent back. Use a 5.5mm nutdriver to remove it.
Thank you very much for your advice.
I had already main circuit board modified and also with TAG/Alge switch instaled. I was not sure how they have to be switched on.
I also found topic posted on September 10, 2002 10:00 PM about TAG 705 and Alge GAZ4 connection and thanks to that I could set it up properly.
Thanks again
Deuce
I had already main circuit board modified and also with TAG/Alge switch instaled. I was not sure how they have to be switched on.
I also found topic posted on September 10, 2002 10:00 PM about TAG 705 and Alge GAZ4 connection and thanks to that I could set it up properly.
Thanks again
Deuce