Skip to main content

The new PR1a photocell was tested at the RMD Speed week events held in Aspen CO this past week. We used in for the close of the Speed Trap for the DH. The TD liked the plastic case with nice round edges for this location. The shot was about 60 meters going from wall to wall on Strawpile in through beam configuration. Alignment was a little tricky with the "hinged posts" as is required under FIS guidelines.

For the SG we installed it behind the B net at the top of Aztec. The shot was a little shorter (about 30 meters) but it was going through one layer of net.



The Aztec split was flawless but the trap missed a few. It was most likely athletes getting under the beam in their tuck.

I liked the 2 - AA batery access, built in sun shield and ability to switch between TX RX and Reflector modes. The form factor is nice too.
Original Post

Replies sorted oldest to newest

This photocell is also the lightest on the market. Notice how CJ Timing www.cjtiming.com
is using a 1/4 x 20 thread bracket normally used for TAG cells. They have put a reducer bushing into the PR1a to bring it down to 1/4 x 20. An ALGE RLS1n would have been too heavy to have allowed this type of application.

Timing professionals such as CJ Timing can also appreciate that they only need to stock ONE type of cell. The PR1a is triple purpose:

Reflector cell on Normal setting
Transmitter cell on TX setting
Receiver cell on RX setting

The FIS finish line configuration uses 4 identical cells with a "SYNC" cable at the transmitter side to complete the set.

Smaller and more versatile than any TAG cell on the market. No more need to have HL 2-31 reflector cells, HL 2-35 through beams, etc, etc. The pro carries 5 PR1a cells and 4 reflectors in their finish kit to handle any single or dual course application.

http://www.phoenix-sports.com/alge_pr1a.htm

Phoenix Sports has shipped over 20 of these cells since their introduction in early December.
Last edited by fkp

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×