Hi All - I have a FinishLynx 2000 camera and C-box and am looking to see if others have connected ALGE Timing and e pistols successfully to a FinishLynx C-box and configured FinishLynx to see the start signal?
Any advice on cabling required (3 pin DMX, Serial or banana) and camera serttings in finishlynx software very much appreciated!
I have also posted in the ALGE section so apologies for any duplication.
Replies sorted oldest to newest
Have you checked with Finish Lynx head office? At one time Lynx bundled the Alge radio system with their cameras for starting (almost 20 years ago now). Big thing is to remember to put in the offset delay into the software when using the Alge stuff.
Thanks for the feedback guys - the answer was to connect the WTN to the Radiolynx transmitter by banana cables rather than to the c-box. All good now..
