Skip to main content

In running the latest version of Split Second Club software, it seems that the displays will not stop and hold an intermediate time, only the finish time. We were running ALGE D-Lines, properly programmed and visible on the COM port in SS. Time to hold the finish display was set at 15 seconds, each rider (a road time trial set up in XC/MTB timing in Split Second with 2 intermediates) would display their running time to the intermediate split, but as soon as the photo eye impulse hit the software, the boards would immediately go blank. Running times would display properly when approaching the finish and then hold for 15 seconds on the photo eye impulse. I didn't see any way in the software to configure a hold for intermediate times. Any thoughts out there?
Original Post

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×