Skip to main content

Reply to "Weak signals and missed finishes?"

We've seen the same thing with the PR1a-W photocell, and its position close to the ground probably doesn't help much.

I understood that the PR1a-W polled the other WTN units to determine the power setting in use. Could it be that it doesn't switch to 100mW correctly?

Last week I hung an extra yellow WTN box between the photocell and the timing hut and received all finish times where I would typically get drop-outs.

This week I need to rig two finish lines (only one active at a time) so I'm going to cable one to the WTN box, hang this fairly, high close to the finish line, and hope it helps passing on the signal from the other, wireless, photocell.
×
×
×
×