Skip to main content

Reply to "TED System"

OK, Jenna is right with the layout of the 2 timers at the start and 2 timers at the finish. By hooking the TED to system A and to the "Start" channel at the finish (system A) using the TED is one way of this to work.

Now if you have another set of TED's you may then connect the RS232 output of the system A timer at the finish to send data to you in the race shack in which the Ted RX will be connected to your serial port of your computer.

This would allow you to "time" the race all from system A and if you "sync" through the TED system for the finish system "A", your .1 delay will not be a factor.

We time with a simplified method locally to allow the "timer..read computer" to be located in the bar and not in the race shack (better view of the race hill than the race shack). The race shack has an S4 with a TED-TX hooked directly to the RS232 output. (data mode).

You will still need 4 timers to pull this off properly.

The second rs232 TED system MUST be on a different freq. so not to interfere with the impulse TED's.
×
×
×
×