Skip to main content

Replies sorted oldest to newest

You did not say what type of display you have.

We are assuming that it is an ALGE (but others have similar controls)

Go into "Setup and Test" in Split Second

Click on Scoreboard and your display should already be there listed.

The "seconds to freeze on a finisher" should be set on 10 seconds as the default.

If that is too long, lower the value with the down arrow or highlight and type a new value in such as 05.

Experiment until you find a value that works for you.

Keep in mind the time required for 2nd run total times.
And this situation occurs in NAT/FIS and Club Unleashed in the same manner?

The DLine uses the exact same protocol as the GAZc and GAz4 displays that proceeded it. Do you have an older GAZ to test with and see if it does the same thing?

There have been some changes to Split Second this season to help with two running displays in Club Unleashed Dual ALGE 2/4. We have not seen any changes to the basic display output with the ALGE selection.

Of course we will look at it in the shop tomorrow.

You should try to see if you have the same issue in Club.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×