New Computer Setup

Is your firewall turned off? This has been an issue in the past

Turn off your wifi on the computer. You should not need to hard code ip addresses. Hub off on the connection box?

I turned the firewall off and the connection box is turned to no. Any other thoughts

Is the NIC in your DELL working at all?

If so, did you try to connect the camera directly to your DELL, using a X-Link cable?
Or connect both, the DELL an the camera to a switch, using patch cables?

The camera doesn't have to be connected to the box at all...

Any other computer within the network?
As we set up out equipment some years ago for the second time, I had the management-pc on 192.168.3.101, the 2nd pc on .3.102 and the pc with the timing-client for connecting to our Seltec-System on .3.103.

I drove nuts, because I didn't see the cameras, which were set themself to 102 and 103...

Ciao

dirk

1. get a crossover cable and connect directly. Are link lights on on both sides?
2. Turn off windows firewall or any other "security" software running that monitors network traffic. Most Virus scanners do this.
3. Be sure your IP address and subnet are set. I always use 192.168.2.# 255.255.255.0
4. Disable the onboard wifi adapter.

I am still facing problem.What are the other remedies?

Have you tried the camera with an older computer set up? Have you tried the networking card/ set up for the computer to connect to a second computer? It does not happen often but there are times when the camera networking card stops working If that is the case the camera needs to be sent back for repairs.

Which version of the Lynx camera are you using? With the new version, you can connect the cat 6 cable from the camera to the computer and bypass the c-box if you are using radiolynx connected to the back of the camera. The older versions you still have to use the c-box. Also in your LAN settings, if you are not using more then one computer to time and do results, I just set the IP and DNS to auto. Start lynx and then plug up or turn on the camera.

As Doug says, turn off the Wireless of the laptop, I have a Thinkpad with that problem, I think is an conflict with drivers or ports, but getting off the Wi Fi the Finishlynx connects well.