Great battery powered timers with headset amp built in. Keep using them!
S3 timer as a “TOD” handtimer
10-15-12
S3
START handtiming
HP PROGRAM
• Hold down Yellow button
• Turn Knob to DIFF
• Release when HP appears
• Insert hours by pressing RED button
• Insert Minutes by pressing Yellow button
• Press START switch down to sync or impulse on Green start jacks
GREEN START JACKS for Sync Impulse. Then connect Start CTS button for Handtiming pulses
RED STOP jacks can be connected to a spare pair of cable running to the finish for headset communication.
FINISH Handtiming
Set up S3 just like for start
HP PROGRAM
• Hold down Yellow button
• Turn Knob to DIFF
• Release when HP appears
• Insert hours by pressing RED button
• Insert Minutes by pressing Yellow button
• Press START switch down to sync or impulse on Green start jacks
GREEN START JACKS for Sync Impulse. Then connect to the spare pair of cable running to the start for headset communication.
RED STOP jacks connected to CTS button for finish pulses
HEADSET TO EET computer inside
Connect a pair of wires from a SV4 amplifier and headset inside the building to the communication line outside. All three stations are now on a parallel line and talking between each other.
MAKE SURE YOU MAIN POLARITY. BLACK TO BLACK = GROUND OR UPSIDE DOWN “T” SYMBOL
S3 8 CHANNEL
HP PROGRAM
SAME A STANDARD S3. THE 8 CHANNEL VERSION HAS A ROW OF RED AND BLACK BANANA PLUGS UNDER THE BATTERY DOOR.
REMOVE ALL BATTERIES AT END OF SEASON. THEY WILL BURST AND RUIN THE INSIDE CIRCUITS ON YOUR S3!
Original Post