Skip to main content

Hi All,

MyLaps ip address is configure on 192.168.2.199 and all cameras and computer are on the 192.168.2.xxx range.

Wetry to connect and make the Laptime plugging work with a mylaps devices. We don't know what is the port to configure to receive data into Lynx software. Anyone has this informations ?

Thanks
Original Post

Replies sorted oldest to newest

So I found my answer and the port to configure is 5100. So you need to configure to network (connect) and specify the network address from the decoder.

Then do not forget that mylaps transponder code written on the chip is not the code recongnize by lynx. You need to find all numerical code from scanning each transponder to lynx without a map file. Then you will be able to map the file with this data collected.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×