Hi,

Today, I update our FinishLynx Software from 7.1 to 7.3.
Everything worked fine and my add-ons were shown at the programm information.

But my RadioLynx stuff (for start and photocell) was no longer working...

I thought, I may have changed some settings - which I didn't.

Finaly, I uninstalled 7.3 and reinstallt 7.1 and Radiolynx was working again...

Strange

dirk

Did you reboot the camera as well as the computer after the upgrade. I have been in the same situation and this resolved it.

I rebooted the computer multiple times - but I didn't reboot the camera...

I will try this, next time, I am out at our indoor facility...

thanks

dirk

Hi, I've been having a lot of problems with radiolynx. Four notebooks wiht three differnt OS. Two with XP, one with Vista and one with W7.
Only W7 with ff7.50 the rest FF7.10 and none cant' recieve signal from RL. All connection are OK. I had to re-install all the FF software because the system was sending the message BAD IP ADDRESS. Now the camera is OK but no RL signal. What can I try?

Try using the Enc radio transmitter and dec radio receiver with the REI2 timer from the velodrome. The REI2 has a built in signal strength "signal quality" feature where you can see if the problem might be in the Enc or Dec radio. Make sure that the small connection between the Dec radio and the REI2 is removed with caution as it will be a snug fit when it is plugged in. Remove the antennas if testing indoors within close range.